Filter
Top Products
OPERATION
SE6 05/05 Operation Section 4-35
© 2005 Alamo Group Inc.
OPERATION
L
ift-Type Mower - To disconnect the mower, first
e
xtend the tractor 3-point hitch top link to remove
t
ension on the top link hitch pin. When the pin is
l
oose and easy to rotate, remove the pin from the
m
ower. Next remove both lower hitch pins.
P
ull-Type Mower - To disconnect the mower, first
r
elieve hydraulic pressure by moving the control
l
ever back and forth several times. Lower the
p
arking jack and raise the mower until the tongue
c
levis in no longer resting on the tractor drawbar
a
nd is supported solely by the jack. Make sure that
t
he jack foot is securely resting at ground level or
s
upported by a block. Then remove the hitch bolt,
l
ocknut, and washers. If a hydraulic cylinder was
u
sed, remove its hose end from the tractor port and
s
ecure it to the mower to prevent contact with dirt.
A
fter disconnecting the 3 lift points, remove the
m
ower driveline from the tractor PTO shaft. Lay the
d
riveline down carefully to avoid damaging the
d
riveline or its shield. Do not let the driveline fall
i
nto mud or dirt, which can contaminate the bearing
a
nd shorten the life of the driveline. OPS-R-0031_A