Filter
Top Products
SAFETY
SE6 05/05 Safety Section 1-8
© 2005 Alamo Group Inc.
SAFETY
I
n case o
f
mec
hi
nca
l
diffi
cu
lt
y
d
ur
i
ng opera
ti
on, p
l
ace
th
e
t
ransm
i
ss
i
on
i
n
th
e par
k
pos
iti
on, se
t
the parking brake, shut down all power, including the PTO and the engine and remove the key.
Wait until all rotating motion has stop before dismounting. (SG-39)
Do Not operate this equipment in areas where insects such as bees may attack you and/or cause
you to lose control of the equipment. If you must enter in such areas, use a tractor with an
enclosed Cab and close the windows to prevent insects from entering. If a tractor cab is not
available, wear suitable clothing including head, face, and hand protection to shield you from the
insects. Attacking insects can cause you to lose control of the tractor, which can result in serious
injury or death to you or bystanders. Never dismount a movingtractor.
(SG-40)
Mow only in conditions where you have clear visibility in daylight or with adequate artificial lighting.
Never mow in darkness or foggy conditions where you cannot clearly see at least 100 yards in
front and to the sides of the tractor and mower. Make sure that you can clearly see and identify
passersby, steep slopes, ditches, drop-offs, overhead obstructions, power lines, debris and
foreign objects. If you are unable to clearly see these type of items discontinue mowing.
(SGM-1)
There are obvious and hidden potential hazards in the operation of this Mower.
REMEMBER! This machine is often operated in heavy brush and in heavy
weeds. The Blades of this Mower can throw objects if shields are not properly
installed and maintained. Serious injury or even death may occur unless care
is taken to insure the safety of the operator, bystanders, or passersby in the
area. Do not operate this machine with anyone in the immediate area. Stop
mowing if anyone is within 100 yards of mower.
(SGM-2)
The rotating parts of this machine have been designed and tested for rugged use. However, the
blades could fail upon impact with heavy, solid objects such as metal guard rails and concrete
structures. Such impact could cause the broken objects to be thrown outward at very high
velocities. To reduce the possibility of property damage, serious injury, or even death, never allow
the cutting blades to contact such obstacles.
(SGM-4)
E
x
t
reme care s
h
ou
ld
b
e
t
a
k
en w
h
en opera
ti
ng near
l
oose o
bj
ec
t
s suc
h
as
gravel, rocks, wire, and other debris. Inspect the area before mowing.
Foreign objects should be removed from the site to prevent machine damage
and/or bodily injury or even death. Any objects that cannot be removed must
be clearly marked and carefully avoided by the operator. Stop mowing
immediately if blades strike a foreign object. Repair all damage and make
certain rotor or blade carrier is balanced before resuming mowing.
(SGM-5)