Filter
Top Products
SAFETY
SE6 05/05 Safety Section 1-15
© 2005 Alamo Group Inc.
SAFETY
Never attempt to lubricate, adjust, or remove material from the Implement while it is in motion or
while tractor engine is running. Make sure the tractor engine is off before working on the
Implement.
(SG-20)
Periodically inspect all moving parts for wear and replace when necessary with
authorized service parts. Look for loose fasteners, worn or broken parts, and
leaky or loose fittings. Make sure all pins have cotter pins and washers.
Serious injury may occur from not maintaining this machine in good working
order.
(SG-21)
Do Not fill gasoline tank while engine is running. Refuel only after engine has cooled down. If
gasoline is spilled, move machine away from the area of the spill and avoid creating any source of
ignition until the gasoline has evaporated.
(SG-28)
Perform service, repairs and lubrication according to the maintenance section. Ensure the unit is
properly lubricated as specified in the lubrication schedule and all bolts and nuts are properly
torqued. Failure to properly service, repair and maintain this Implement in good operating
condition could cause component failure and possible serious injury or even death.
(SG-35)
U
se cau
ti
on an
d
wear pro
t
ec
ti
ve g
l
oves w
h
en
h
an
dli
ng s
h
arp o
bj
ec
t
s suc
h
as
bl
a
d
es,
k
n
i
ves, an
d
other cutting edges. Be alert to worn component surfaces which have sharp edges. Sharp
surfaces can inflict severe laceration injuries if proper hand protection is not worn.
(SG-37)
All Safety Shields, Guards and Safety devices including (but not limited to)
- the Deflectors, Chain Guards, Steel Guards, Gearbox Shields, PTO
integral shields, and Retractable Door Shields should be used and
maintained in good working condition. All safety devices should be
inspected carefully at least daily for missing or broken components.
Missing, broken, or worn items must be replaced at once to reduce the
possibility of injury or death from thrown objects, entanglement, or blade
contact.
(SGM-3)
Replace bent or broken blade with new blades. NEVER ATTEMPT TO STRAIGHTEN OR WELD
ON BLADES SINCE THIS WILL LIKELY CRACK OR OTHERWISE DAMAGE THE BLADE
WITH SUBSEQUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN BLADES.
(SGM-10)