Filter
Top Products
ASSEMBLY
VERSA PRO 03/09 Assembly Section 3-11
© 2009 Alamo Group Inc.
ASSEMBLY
INSTALLATION OF CENTER MOWER
ASM-FL-0111
1. To properly attach center mower to mainframe, align lower links (1) to overarms (2) and anti-sway bar (3).
Attach with 7/8" x 5" bolt and 7/8" locknut (4).
2. Align toplink (5) with top of A-frame (6) on center mower and retain with pin (7), washers (8), and cotter
pins. Attach the other end of the toplink to the mainframe. Install 1" x 4" bolt through safety chain and
retain with 1" locknut.
3. Continue with driveline by aligning slipclutch and gearbox shaft and slide slipclutch in and tighten bolt. On
the other end of driveline pull slide collar back, slip into speed increaser shaft and release slide collar.
Move driveline in and out to insure driveline is secure.
4. Level front unit by adjusting top link. Be sure skid shoes are level with ground.
NOTE: Front Caster Wheels should be set about 2-4 inches above ground when mower is level.