Filter
Top Products
OPERATION
VERSA PRO 03/09 Operation Section 4-3
© 2009 Alamo Group Inc.
OPERATION
88” Cutting Width
Two 10-Gauge Unitized Cutter Housings
1/2” Inboard and 5/16” Wall Cuttershaft
Replaceable Skid Shoes
4-1/2” x 5/16” Wall Cuttershaft
1-5/16” Bore Greasable, Self-aligning Cuttershaft Bearings
53 HP Motor
Belt Drive From Motor to Cuttershaft with Automatic Spring Tension
6” Adjustable Rear Roller
1/2” to 6” Cutting Height
Available in Fine or Coarse-Cut
Front and Rear Safety Deflectors
Automatic Cut-Off Switches
Wing Cylinder Capable of 145 degrees Down & 90 degrees Up
FRONT MOWER SPECIFICATIONS
96” Cutting Width
10-Gauge Unitized Cutter Housing
5/16” Side Plates
4-1/2” x 5/16” Wall Cuttershaft
1-5/16” Bore Greasable, Self-aligning Cuttershaft Bearings
60 HP Gearbox
6” Adjustable Rear Roller
1/2” to 6” Cutting Height
Available in Fine or Coarse Cut
Front and Rear Safety Deflectors
Belt Drive from Gearbox to Cuttershaft with Automatic Spring Tension
Th
e
M
ower
i
s
d
es
i
gne
d
f
or cer
t
a
i
n mow
i
ng app
li
ca
ti
ons an
d
i
s ra
t
e
d
t
o cu
t
up
t
o a spec
ifi
c
size vegetation (see Mower Standard Equipment and Specifications). DO NOT use this
mower to cut vegetation above the Mower’s rated capacity or to cut any type of non-
vegetative material. Only operate this Mower on a properly sized and equipped Tractor.
Operating this Mower in an application for which it is not designed and/or operating the
Mower with the wrong size Tractor can cause Mower component damage and equipment
failure resulting in possible serious injury or death.
(SGM-14)