Filter
Top Products
MAINTENANCE
VERSA PRO 03/09 Maintenance Section 5-2
© 2009 Alamo Group Inc.
MAINTENANCE
DAILY CHECKS
1. Lubricate the VERSA PRO at the specified intervals as outlined in the lubrication diagram. All mower
grease fittings are equipped with lubricaps which snap over the grease fittings to prevent dirt from
entering the fittings. Remove the cap and wipe the fitting before greasing. Wipe the outlet of the
grease gun then grease the bearing. When finished, place the cap over the fitting and wipe any excess
grease from around the cap. In extremely dusty conditions, it is desirable to lubricate more often than
every 8 hours. Grease PTO shaft as outlined on the diagram located on PTO shaft shield. The idler
pulleys are equipped with a sealed ball bearing and require no further lubrication. Caster wheel
bearings should be repacked at the end of each mowing season and checked before the start of the
next season. The gearbox is shipped with the proper amount of SAE No. 90 extreme pressure
lubricant. Maintain the level of this oil at the lower 1/8" pipe plug on the gearbox cover. LUBRICATE
MOWER BEFORE INITIAL USE.
2. Before each day's use, follow this procedure:
Visually check the unit, and make certain all items are properly tightened.
NOTE: Cutter unit belt tension is maintained by a spring-loaded idler pulley.
Check the reservoir fluid level with the cutter units in the transport position. The oil level should be even with
the sight glass located on the reservoir. Before removing filler cap, wipe the top of the reservoir to prevent dirt
from entering the tank.
NOTE: If the reservoir needs oil, a leak exists somewhere in the system. Repair the leak before using the unit.
Check the cuttershaft to make certain it is fully knifed. Replace any missing knives or cotter pins, then run the
unit at full speed to check for vibrations. Do not operate the unit in an out-of-balance condition.
Before doing maintenance, turn off power, and securely block up mower.