A SERVICE OF

logo

Open as PDF
next previous
MDS-D-SVJ3/SPJ3 Series Instruction Manual
2-2 Main circuit terminal block/control circuit connector
2 - 15
(b) When using the flat-blade screwdriver
[1] Applicable flat-blade screwdriver dimensions
Always use the screwdriver shown here to do the work.
[Unit:mm]
[2] Cable connection procedure
0.6
(R0.3)
(22)
3°
3㨪3.5
(R0.3)
1)
2)
3)
4)
Insert the screwdriver into the square hole.
Insert it along the top of the square hole to insert it smoothly.
If inserted properly, the screwdriver is held.
With the screwdriver held, insert the cable in the direction of arrow.
(Insert the cable as far as it will go.)
Releasing the screwdriver connects the cable.