A SERVICE OF

logo

Open as PDF
next previous
Appendix 2 - 28
Appendix 2 Cable and Connector Assembly
MITSUBISHI CNC
Turn the form of the ground clip back to normal and position it for the receptacle case as shown below.
Adjust the projection of receptacle housing to the slit of the receptacle case and push in until it is fixed to
the case.
(Note) See that the contact of receptacle housing goes inside a ground clip.
(8) Shift the wire rubber packing and wire clamp to the position below, and tighten the wire fixed set screw
to fix the cable to receptacle case.
Tighten it not to create the space between the receptacle case and wire fixed set screw.
(Note) Confirm that the cable is fixed.
Push
Projection
Contact
Slit
A ground clip is stuck in a receptacle case.
No space
No space