3. PROGRAM ERROR
I - 67
Error No. Details Remedy
P202 BLOCK OVR (MRC)
The number of blocks in the shape
program of the fixed cycle for compound
lathe I is over 50 or 200 (this differs
according to the model).
• Specify 50 or a less value. The number of
blocks in the shape program called by the
fixed cycle for compound lathe I commands
(G70 to G73) must be decreased below 50 or
200 (this differs according to the model).
P203 CONF. ERR (MRC)
The fixed cycle for compound lathe I
(G70 to G73) shape program could not
cut the work normally because it defined
an abnormal shape.
• Check the fixed cycle for compound lathe I
(G70 to G73) shape program.
P204 VALUE ERR (MRC)
A command value of the fixed cycle for
compound lathe (G70 to G76) is illegal.
• Check the fixed cycle for compound lathe
(G70 to G76) command value.
P210 NO PAT CYC SPC
A fixed cycle for compound lathe II (G74
to G76) command was input although it
was undefined in the specification.
• Check the specification.
P220 NO SPECIAL CYC
No special fixed cycle specifications are
available.
• Check the specifications.
P221 NO HOLE (S_CYC)
A 0 has been specified for the number of
holes in special fixed cycle mode.
• Reconsider the program.
P222 G36 ANGLE ERR
A G36 command specifies 0 for angle
intervals.
• Reconsider the program.
P223 G12 G13 R ERR
The radius value specified with a G12 or
G13 command is below the
compensation amount.
• Reconsider the program.
P224 NO G12‚ G13 SPC
There are no circular cutting
specifications.
• Check the specifications.
P230 NESTING OVER
• A subprogram has been called 8 or more
times in succession from the subprogram.
• The program in the IC card contains the
M198 command.
• The program in the IC card has been
called more than once (the program in the
IC card can be called only once at a time).
• Check the number of subprogram calls and
correct the program so that it does not
exceed 8 times.
• When using the IC card, the IC card and the
number of IC card program calls.
P231 NO N-NUMBER
At subprogram call time‚ the sequence
number set at return from the
subprogram or specified by GOTO‚ was
not set.
• Specify the sequence numbers in the call
block of the subprogram.
• When using an IC card, check the program
and its No. in the IC card.
