5. BASE SPECIFICATIONS PARAMETERS
II - 66
# Items Details Setting range (unit)
1238
(PR)
set10
(bit0)
Switch G36
function
If a G code system containing the G36 (automatic
tool length measurement X) function is selected,
select whether to use G36 for the automatic tool
length measurement or arc thread cutting (CCW)
function.
0: Automatic tool length measurement
1: Arc thread cutting (CCW)
0/1
set10
(bit7)
Switch
operation alarm
Select whether to validate the NC alarm 5 (AL5)
signal output.
0: NC alarm 5 (AL5) invalid
All operation alarms are output to NC alarm 4
(AL4).
All operation alarms are recorded in the alarm
history.
1: NC alarm 5 (AL5) valid
The following operation alarms are not output
to NC alarm 4 (AL4). These are output to NC
alarm 5 (AL5).
The operation alarms output to NC alarm 5
(AL5) are not recorded in the alarm history.
• External interlock axis found
• Cutting override zero
• External feedrate zero
• Block start interlock
• Cutting block start interlock
0/1
(Default: 0)
1239
(PR)
set11
(bit0)
Coil switching
method
0: Via PLC. (Y2D7)
1: NC internal processing. (Y2D7 is invalid.)
0/1
set11
(bit5)
Door interlock
spindle speed
clamp valid
Select whether to validate the spindle clamp speed
changeover function by the PLC signal.
0: Invalid
1: Valid
0/1
set11
(bit6)
External
deceleration
axis compliance
valid
Designate the method for setting the external
deceleration speed.
0: Set speed common for all axes (#1216 extdcc
external deceleration speed)
1: Set speed for each axis (#2086 exdcax
external deceleration speed)
0/1
1240
(PR)
set12
(bit0)
Handle input
pulse
Select the handle input pulse.
0: Handle 100 pulse (+12V)
1: Handle 400 pulse (+5V)
0/1
set12
(bit2)
Zero point shift
amount
magnification
If "1" is set, the following magnification will be
applied on the #2027 G28sft reference point shift
amount, #2057 zero point proximity + and #2058
zero point proximity - settings.
For 0.1µm : 10-fold
0/1
