RAM Mount System 23
E-EQ-VX3XOGWW-E VX3X User’s Guide
Procedure
Step 1 – Mount Vehicle RAM Clamp Mount
1. Determine the position for mounting
the RAM clamp mount. The clamp
mount can be used on a beam (such
as on a fork lift truck) up to 2.5”
(63.5 mm) wide and approximately
2” (50.8 mm) thick. The clamp may
be attached to a thicker beam by
substituting longer bolts (not
included). Be sure to position the
RAM clamp mount to allow access
to the switches and ports on the
VX3X.
2. Position the upper clamp piece with
ball (A) on the beam. Place the bolts
(B) through the holes in the upper
clamp piece.
3. Position the lower clamp piece (C)
below the beam. Align the bolts with
the holes in the lower clamp piece.
4. Place the nylon locking nuts (D) on
the bolts and tighten the bolts.
Figure 10 RAM Clamp Mount
Components
Figure 11 Assembled RAM Clamp Mount
