HP Jetdirect Configuration Page Messages 8-9
Config. Page
Messages
8
LAN ERROR-
REMOVE RECEIVE
Run the power-on self-test: turn the printer off, then
on again. If this message reappears on the resulting
configuration page, you may have a problem with one
of the HP Jetdirect print servers on your network.
Check all the HP Jetdirect print servers on the network
for proper operation.
LAN ERROR-
RETRY FAULTS
There is a problem with your network cabling or external
network configuration. Make sure that your network
cable is correctly terminated at both ends. Verify
operation of the hub or switch port.
LAN ERROR-
TRANSMITTER
OFF
There may be a problem with your network cabling or
the HP Jetdirect print server. Check the cabling on your
Ethernet network. If you cannot find a problem with your
network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists, there is
a problem with the HP Jetdirect print server.
LAN ERROR-
UNDERFLOW
There may be a problem with your network cabling or
the HP Jetdirect print server. Check the cabling on your
network. If you cannot find a problem with your network
cabling, run the power-on self-test: turn the printer off,
then on again. If the error persists, there is a problem
with the HP Jetdirect print server.
LAN ERROR-WIRE
FAULT
There is a problem with the network cabling. Check the
cabling between the printer and the network.
LAN HW ADDRESS:
XXXXXXXXXXXX
The 12-digit hexadecimal network address of the
HP Jetdirect print server installed in the printer.
LATE COLLISION
ERROR
Check the network topology, verify all cable segments,
and make sure no segment is too long.
LOSS OF CARRIER
ERROR
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off,
then on again. If the error persists, call the Customer
Care Center (see Chapter 1 for telephone numbers).
Table 8.2 General HP Jetdirect Messages (6 of 15)
Message Description
0Book-asF01.book Page 9 Tuesday, August 14, 2001 2:06 PM
