ENGLISH
52
SPECIAL SETTINGS
----------------------------------------------------------------------------------------------------------
6 Select the line »Scan Typ« with »
C
« or »
D
«
and set the option
»DTV« with »
B
« or »
A
«.
7 Start the scan with
»●« (red).
– All channel and favourites lists will be
deleted and compiled anew.
Note:
7
After starting the scan, a security query will
appear. Press »●« (green) to confirm the
option
»Yes«.
– The
»Reults« menu appears, and the scan
for TV channels begins. Depending on the
number of television channels received,
this can easily take a few minutes.
– The scan is complete as soon as the
»PROGRAM TABLE« appears.
8 Press
»M« to end the setting.
Automatic service update
If this function is activated, possible changes of
network operators are updated automatically.
The unit must be located in stand-by mode.
1 Open the menu with
»M«.
2 Select the line
»SOURCE SETUP
«
with »
C
«
or
»
D
« and press
»OK«
to confirm.
3 Select the line
»Automatic Service Update«
with
»
C
« or »
D
«.
4 Select the automatic update with
»
B
« or
»
A
« (»On«).
5 Press
»M« to end setting.
Searching for digital terrestrial
TV channels manually
1 Open the menu with »M«.
2 Select the line
»SOURCE SETUP« with »
C
«
or
»
D
« and press »OK« to confirm.
– The
»SOURCE SETUP« menu appears.
3 Select the line
»Source« with »
C
« or »
D
«
and press
»OK« to confirm.
Select the option
»Air« with »
B
«, »
A
«, »
C
«
or
»
D
« and press »OK« to confirm.
Caution:
7
The antenna power supply (line »Active
Antenna Power
«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4 Select the
»Active Antenna Power«« with
»
C
« or »
D
«. Switch on the antenna power
supply for the antenna with
»
B
« or »
A
«
(
»On«).
5 Select
» Digital Manual Tuning« with »
C
« or
»
D
« and press »OK« to confirm.
– The menu appears.
6
Enter the channel number directly with
»1 ... 0« and press »OK« to confirm.
– After the search is complete, the channels
found are displayed in the
»Results« menu.
7 Press
»M« to finish the setting.
