Filter
Top Products
7
serious burns or electrical shock.
■ IF SOMEONE COMES
1. Guard against hazardous situations at
all times. Warn adults to keep pets and
children away from the area. Be careful
if you are approached. Injury may
result from flying debris.
2. If someone calls out or otherwise
interrupts you while working, always be
sure to turn off the engine before
turning around.
■ MAINTENANCE
1. In order to maintain your product in
proper working order, perform the
maintenance and checking operations
described in the manual at regular
intervals.
2. Always be sure to turn off the engine
and disconnect the spark plug wire
before performing any maintenance or
checking procedures.
The metallic parts reach high
temperatures immediately after
stopping the engine.
3. When replacing the cutting attachment
or any other part, or when replacing
the oil or any lubricant, always be sure
to use only ZENOAH products or
products which have been certified
by ZENOAH for use with the
ZENOAH product.
4. In the event that any part must be
replaced or any maintenance or repair
work not described in this manual must
be performed, please contact a
representative from the store nearest
ZENOAH authorized servicing dealer
for assistance.
5. Do not use any accessory or
attachment other than those bearing
the ZENOAH mark and recommended
for the unit.
6. Under no circumstances should you
ever take apart the product or alter it in
any way. Doing so might result in the
product becoming damaged during
operation or the product becoming
unable to operate properly.
WARNING
■ HANDLING FUEL
1. The engine of the ZENOAH product is
designed to run on a mixed fuel, which
contains highly flammable gasoline.
Never store cans of fuel or refill the
tank of the unit in any place where
there is a boiler, stove, wood fire,
electrical sparks, welding sparks, or
any other source of heat or fire which
might ignite the fuel.
2. Never smoke while operating the unit
or refilling its fuel tank.
3. When refilling the tank, always turn off
the engine and allow it to cool down.
Take a careful look around to make
sure that there are no sparks or open
flames anywhere nearby before
refueling.
4. Wipe spilled fuel completely using a
dry rag if any fuel spillage occurs
during refueling.
5. After refueling, screw the fuel cap back
tightly onto the fuel tank and then carry
the unit to a spot 3 m or more away
from where it was refueled before
turning on the engine.
■ TRANSPORTATION
1. When hand-carrying the product, cover
over the cutting part if necessary, lift up
the product and carry it paying
attention to the blade.
2. Never transport the product over rough
roads over long distances by vehicle
without removing all fuel from the fuel
tank. If doing so, fuel might leak from
the tank during transport.
■ CONTROLLING BLADE THRUST
Blade thrust can cause serious
personal injury. Carefully study this
section. It is important that you
understand what causes blade thrust,
how you can reduce the chance of
blade thrust and how you can remain
in control of the unit if blade thrust
does occur.
1. What causes blade thrust:
Blade thrust can occur when the moving
blade contacts an object that it cannot cut.
WARNING
4. Safety precautions