Filter
Top Products
10
■ INSTALLING BLADE
Remove the guard skirt of debris guard, when using
metal blade.
1. Put the hexagonal bar into the side holes of the
holder A and the gearcase.
2. Remove the nut(Left-handed) and the holder B from
the gearshaft.
3. Put the blade onto the holder A. Make the marked
side face the holder.
4. Put the holder B onto the gearshaft making the
recessed side face the blade.
5. Fasten the blade by the nut and the cover.
(1) Hexagonal bar
(2) Holder A
(3) Holder B
(4) Cover
■ BLADE
• Do not install or remove the blade while the
engine is in operation.
• Use ZENOAH’s genuine replacement blades and
metal fixtures when installing the blade.
• When installing or removing the blade, fix the
machine securely, and wear robust gloves.
• The blade turns counterclockwise (viewed from
the gear case). When using an inside-out blade,
check the direction of the blade before installing
it. In particular, if you install a chip saw in the
wrong direction, the chips might break and
scatter.
WARNING
5. Set up
SE7
Look at the blade from above, and make sure that the
direction in which the blade is mounted is correct. (SE8)
(1) Rotating direction
■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with head
aparting from the ground when using it.
IMPORTANT
SE9
SE8