Filter
Top Products
13
2.When the cutting head keeps rotating after releasing
the trigger, turn the adjusting screw counter-
clockwise.
(1) Idle adjusting
screw
Warm up the engine before adjusting the idling speed.
■ CUTTING WORK
• By using the shoulder strap, hang the unit on your
right side. Adjust the strap length so that the cutting
head may become parallel to the ground.
(1) Shoulder strap
• Choose a suitable recommended cutting attachment
according to the object to be cut.
Be sure to use ZENOAH genuine cutting attachments.
Other cutting attachments are not included in the
warranty.
■ LINE HEAD USAGE
1.Always wear eye protection such as safety
goggles. Never lean over the rotating cutting
head. Rocks or other debris could be thrown into
WARNING
NOTE
OP8
1.When restarting the engine immediately after stopping
it, leave the choke open.
2.Overchoking can make the engine hard to start due to
excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
■ STOPPING ENGINE
1.Release the throttle trigger and run the engine for half
a minute.
2.Shift the stop switch to the STOP position.
(1) Stop switch
Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
■ ADJUSTING THROTTLE CABLE
• The normal play is 1 or 2 mm when measured at the
carburetor side end. Readjust with the cable adjuster
as required.
(1) Cable adjuster
(1) Cable adjuster
■ ADJUSTING IDLING SPEED
1.When the engine tends to stop frequently at idling
mode, turn the adjusting screw clockwise.
IMPORTANT
NOTE
(1)
OP5
7. Operation
1~2mm
(1)
OP6
OP9
OP10
OP7