Filter
Top Products
14
eyes and face and cause serious personal injury.
2.Keep the debris guard attached in place at all
times when the unit is operated.
TRIMMING GRASS AND WEEDS
• Always remember that the TIP of the line does
cutting. You will achieve better results by not crowding
the line into the cutting area. Allow the unit to trim at
its own pace.
1.Hold the unit so the head is off the ground and is tilted
about 20 degrees toward the sweep direction.
2.Use full throttle when cutting.
3.You can avoid thrown debris by sweeping from your
left to the right.
4.Use a slow, deliberate action to cut heavy growth. The
rate of cutting motion will depend on the material
being cut. Heavy growth will require slower action
than will light growth.
5.Never swing the unit so hard as you are in danger of
losing your balance or control of the unit.
6.Try to control the cutting motion with the hip rather
than placing the full workload on the arm and hands.
7.Take precautions to avoid wire, grass and dead, dry,
long-stem weeds from wrapping around the head
shaft. Such materials can stall the head and cause the
clutch to slip, resulting in damage to the clutch system
if repeated frequently.
ADJUSTING THE LINE LENGTH
• Your brushcutters is equipped with a semi- auto type
nylon line head that allows the operator to advance
the line without stopping the engine. When the line
becomes short, lightly tap the head on the ground
while running the engine at full throttle.
• Each time the head is bumped, the line advance
about 1 inch(25.4 mm). For better effect, tap the head
on bear ground or hard soil. Avoid bumping in thick,
tall grass as the engine may stall by overload.
7. Operation