Filter
Top Products
12
5.Set the stop switch to the “RUN” position.
Place the unit on a flat, firm place.
Keep the cutting head clear of everything around it.
(1) Stop switch
6.While holding the unit firmly, pull out the starter rope
quickly until engine fires.
The product is equipped with a centrifugal clutch
mechanism, so the cutting attachment begins to
rotate as soon as the engine is started by putting
the throttle into the start position. When starting the
engine, place the product onto the ground in a flat
clear area and hold it firmly in place so as to ensure
that neither the cutting part nor the throttle come
into contact with any obstacle when the engine
starts.
Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
7.Move the choke lever downward to open the choke.
And restart engine.
8.Allow the engine to warm up for a several minutes
before starting operation.
IMPORTANT
WARNING
■ REFUELING
•Refuel the fuel tank in a flat place outdoors. Avoid
smoking or bringing any flame or spark near the
fuel, and stub out any cigarette.
• When refueling the fuel tank while using this
machine, make sure to stop the engine and allow
it to cool before refueling the fuel tank.
• Make sure to tighten the fuel-tank cap firmly.
•Wipe up all fuel spills with a dry cloth before
starting the engine.
Fill the fuel tank to roughly 80% of its capacity.
If filled too full, the fuel may leak from the tank cap while
using this machine.
1. Place the brushcutter to be refueled in a flat place
outdoors, and make sure it is stable.
2. Unscrew the fuel-tank cap a little, and allow the
difference of atmospheric pressure between the
inside and outside of the fuel tank to equalize.
3. Remove the fuel-tank cap, and fill fuel little by little up
to roughly 80%.
4. After filling the fuel, close the fuel-tank cap tightly,
and make sure that the fuel does not leak.
■ STARTING ENGINE
The cutting head will start rotating upon the engine
starts.
1.Feed fuel into the fuel tank and tighten the cap
securely.
2.Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects,
as it will start rotating upon starting of the engine.
3.Push the primer pump several times until overflown
fuel flows out in the clear tube.
(1) Choke lever
(2) Close
(3) Open
(4) Primer pump
4.Move the choke lever to the closed position.
WARNING
IMPORTANT
WARNING
7. Operation
OP1
(1)
OP2
OP3
OP4