Filter
Top Products
MAN0556 (9/21/2007)
Installation 37
4. Open the grapple slightly (enough to remove some
pressure from the pins).
5. Remove the pins that attach the grapple to the
bucket (tools may be required to get the pins out)
6. Uncouple the hydraulics.
7. Remove the cap screws that attach the grapple grill
to the bucket.
8. Rotate the grapple grill back over center so that it
won't swing down when the bucket is moved
(secure with bungee straps if necessary).
Figure 49. Remove grapple
9. Lower the bucket and back the tractor away.
10. Lower the grapple grill so that it won't be able to fall
down and cause damage to the cylinder ports.
Install Grapple
1. Raise the grapple grill so that it is out of the way
and will not swing down (secure with bungee
straps if necessary).
2. Roll the bucket completely forward
Figure 50. Align Bucket with Grapple
3. Drive the tractor forward and align the bottom holes
of the grapple with the bottom set of grapple
mounts on the bucket and insert the pins. NOTE:
this may require two people.
4. Roll the bucket back and align the front holes and
insert pins.
5. Attach the grapple grill to the bucket using cap
screws and nuts.
6. Hook up the hydraulics.
7. Raise the loader and roll the bucket back.
Pins
Removed
4 X 4
Grapple
Grill
(Rev. 1/6/2011)