Filter
Top Products
MAN0556 (9/21/2007)
Assembly 33
Figure 40. Bucket Level Indicator Installed
Grease Loader
Lubricate all pivot points shown on page 22 with a high
quality SAE multi-purpose grease.
Grapple Installation (Optional)
1. With the bucket attached to the loader, roll bucket
forward until the back of it is parallel with the
ground.
2. Secure right (2) and left (3) grapple attachment
brackets to back of bucket using four (two per
bracket) pins (15) and klik pins (23).
3. Place grapple grill (6) between attachment
brackets and secure to lug on bucket with cap
screws (28) and nuts (29).
4. Secure grapple grill (6) to right and left attachment
bracket using cap screws (28) and nuts(29).
5. Attach grapple arm (4) to right attachment bracket
using pin (18), cap screw (26) and lock nut (27).
6. Secure base end of cylinder to attaching bracket
using pin (17), cap screw (26) and lock nut (27).
7. Repeat steps to secure second grapple arm (4)
and cylinder to left attachment bracket.
8. Roll bucket back until front pads of grapple arms
(4) are level with the ground.
9. Place grapple toothbar (5) under grapple arms and
secure using eight (four per arm) cap screws (25),
sixteen hardened flat washers (21) and lock nuts
(20).
Figure 41. Grapple Assembly
2. Attachment bracket - right
3. Attachment bracket - left
4. Grapple arm
5. Grapple toothbar
6. Grapple grill
15. Hitch pin, 1.25 x 4.63
17. Pin, 1.25 x 5.50
18. Pin, 1.25 x 6.68
20. 5/8 NC Lock nut
21. 5/8 Hardened flat washer
23. Klik pin, 7/16 x 2
25. 5/8 NC x 2-1/2 HHCS GR8
26. 5/16 NC x 2-1/4 HHCS GR5
27. 5/16 NC Lock nut
28. 1/2 NC x 1-1/2 HHCS
29. 1/2 NC nut
(Rev. 1/6/2011)