Filter
Top Products
36 Installation
MAN0556 (9/21/2007)
To provide necessary balance, loader frame
must be equipped with bucket or attachment
before attaching or detaching from tractor, or when
loader is in stored position.
Do not climb or lean on equipment stored on
stand.
Keep children and bystanders away from stor-
age area.
CONNECT LOADER SUPPLY HOSES TO
LOADER
Refer to Loader Mounting Kit Manual for hose kit instal-
lation.
Connect loader supply hoses to loader feedlines at the
right side of the loader. Always use hoses that have a
minimum working pressure rating of 3000 psi and meet
or exceed SAE 100R1 specifications.
Figure 47. Loader Supply Hose Connection
VERIFY CONTROL MOVEMENTS
Check that all tractor hydraulic control lever positions
operate the loader movements correctly. See Figure
48.
If loader movements do not respond correctly, shut off
tractor, relieve pressure, and reconnect properly.
Loader control movements must be correct before pro-
ceeding.
Once all loader functions are correct, start the tractor
and operate the loader to check for leaks. Purge any
remaining air from the hydraulic system and check oil
level.
When hose routing and correct loader operations are
verified, identify each circuit by placing a matching col-
ored band around the male and female quick coupler.
The color-coded bands will make reinstallation easier
when the loader is removed from tractor.
Figure 48. Single Lever Control Operation
GRAPPLE ASSEMBLY (OPTIONAL)
Remove Grapple
Block equipment securely for storage.
To help prevent injury caused by a falling imple-
ment, always detach on a hard level surface.
Keep children and bystanders away from stor-
age area.
1. On a hard level surface, raise bucket and roll it
completely forward.
2. Place 4x4 blocks underneath the grapple arms
near the rod ends of the cylinders.
3. Lower the bucket and set it down so the grapple
arms rest on the 4x4's and the toothbar rests on
the ground.
CAUTION
● Handle forward - Boom down
● Handle forward to limit - Float position
● Handle back - Boom up
● Handle right -
Dump bucket or attachment (slow)
● Handle to left - Rollback bucket or attachment