Filter
Top Products
32 Assembly
15916 (Rev. 3/30/2007)
Figure 26. Assembly of MD80 (Mounted Model)
MD80 Assembly (Figure 26)
Driveline Installation
Loosen clamp bolt (36) on rear half of drive. Install key
(32) in gearbox keyway and slide drive onto gearbox
input shaft. Install cotter key (39) and tighten clamp
bolt. Snap tether chain (40) to gear stand to prevent
driveline shield rotation.
Tailwheel Installation
Attach tailwheel bracket (34) to cutter frame with bolts
(23) and lock nuts (10). Attach tailwheel arm brackets
(19) to brackets on rear of cutter frame with bolts (22)
1. Hitch pin
2. Mast plate
3. A-frame half
4. 7/8 x 1-1/8 x 19/32" Sleeve
5. Support brace
6. 3/4" Flat washer
7. 13/16 x 1-9/16 x 10 GA Washer
8. 3/4" Slotted hex nut
9. 5/8 x 1-1/2" Bolt
10. 5/8" Hex lock nut
11. 3/4 x 4-1/2" Bolt
12. Lift channel
13. Spacer bushing
14. 3/4" Hex lock nut
15. Top link pin
16. 5/8 x 3-3/4" Clevis pin
17. Hitch stop
18. 5/8 x 4-1/2" Bolt
19. Tailwheel arm bracket
20. Tailwheel
21. 5/8" Elastic stop nut
22. 5/8 x 2" Bolt
23. 5/8 x 1-3/4" Bolt
24. 5/8" Flat washer
25. 3/4 x 8" Clevis pin
26. Tailwheel mounting bracket
27. Rebound pad support
28. Rebound pad
29. 3/8 x 1" Bolt
30. 3/8" Flange hex nut
31. 3/16 x 1-1/2" Cotter pin
32. 3/8 x 3/8 x 2" Key
33. 3/4 x 6-7/8" Clevis pin
34. Tailwheen bracket
35. Rear drive half
36. Clamp bolt
37. 1/2" Lock washer
38. 1/2" Hex nut
39. 1/4 x 3" Cotter pin
40. Tether chain