Filter
Top Products
User manual W3532
- 9 -
Disconnection of the travel drive
If it is necessary to manually move the self-moving rotary
cutter without the engine started, it is necessary to release belt
“V” according to Fig.7. When the hydro-drive is disconnected
it is forbidden to activate the engine! Therefore, after
relocation, immediately tighten the bolt again.
Adjustment of the seat
The adjustment of the seat is performed by means of lever
“S” according to Fig.7a.
Fig.7a
Activation
Important!
It is permitted to run the engine in the open air or a well
ventilated room. Remember that exhaust gases from the
engine are toxic.
Before the activation of the engine it is necessary to perform
the following operation:
1. Brake pedal – press into the braked position.
2. Switch for activation of blade drives – position OFF.
3. Choke rod – draw up outward = position START
Gas lever – in position MIN.
4. During starting, take care to correctly insert the
key to prevent its breaking! Insert the key into the
ignition box (Fig.8) and turn it into position “1” (the
current circuit is activated)
5. Turn the key into the START position for starting
the engine. After activation release the key. Insert the
control lever of the choke into the initial position.
In the case of activation with a warm engine it is not
necessary to use the choke (START position).
Fig.8
Description of Fig. 8.
“0” OFF
“1” Lighting, running of engine
“2” Running the engine, without lighting
“3” Start engine
Note
If during the starting of the engine there are any problems,
do not start the engine because there could be discharging
of the accumulator and overheating of the engine. Return
the ignition key to the position “0”, wait several seconds
and then repeat the procedure. If it is not possible to start,
read the instructions in the User Manual for using the
engine.
Important!
If the accumulator is discharged do not use cables for
starting, this could destroy the electrical installation!
Disconnect the accumulator from the electrical installation
of the cutter and charge it with the charging device.
After the termination of work it is necessary to regularly
check the level of electrolyte and the status of charging of
the accumulator, minimally 1 x in a month. If necessary
charge the accumulator, otherwise there is the risk of
damage. We recommend removing the accumulator from
the machine and placing it on a dry, hot place.
It is necessary to make sure that the security measure does
not prevent the starting of the engine, such as:
- the machine is not braked
- the drive of the cutting mechanism is ON
Travel (Fig.3b, pos.3)
The travel of the machine is controlled by the travel pedal
which is located on the right side of the platform. The fluency
of the driving is controlled by the fluent control of pedal.
front (wider) part of pedal - driving in forward
direction
rear part of the pedal – driving in backward
direction