Filter
Top Products
User manual W3532
- 25 -
9. Maintenance of accumulator
Safety precautions during use and installation
A 12V car filling accumulator is used. The electrolyte is completed in the production plant and is charged to
the required capacity of 32Ah.
The filling and adding of electrolyte must be performed by professional service.
ATTENTION!
Important:
After termination of the work it is necessary to regularly check the level of electrolyte and the status of the
charging of the accumulator, minimally 1 x in a month.
If it is necessary (difficulty in starting, decrease of intensity of lighting, etc.) to charge the accumulator,
there is a risk of its damage.
After termination of seasonal work we recommend removing the accumulator from the machine and to place
it in a dry warm place.
Charging of accumulator
Before charging, dismantle the filling cap and check the level of electrolyte. If you ascertain a small decrease
in the level of electrolyte, it is necessary to add distilled water up to the “UPPER LEVEL”.
In the case of a large decrease in the level, contact a professional service.
Charge the accumulator by the maximum current 3A. Charge until the accumulator starts to boil and the
specific density of electrolyte exceeds 1.27.
Installation
Fix the accumulator firmly into the machine. Make sure that the positive and negative poles of the
accumulator are connected correctly.
Maintenance of accumulator
1. Once a month check the level of electrolyte.
2. Use distilled water for renewing the level. Never use electrolyte for increase the level.
3. Always keep the accumulator clean.