Filter
Top Products
www.clearcreekspas.com
www.clearcreekspas.com
INSTALLATION
Important: Read complete instructions before beginning installation.
Positioning Your Spa
Because your Quantum Plus spa is a portable, you can locate it just about anywhere you wish—on a deck, patio, or even
indoors. Just be sure to position it above ground in an area with good drainage and on a level, continuous surface which
can support the weight of the spa when filled with water and people; this weight is approximately 5252 lbs. (92 lbs. per sq
ft). You must also provide access to the spa’s equipment for service and general maintenance.
SERVICE ACCESS
18"
50"
Electrical Requirements
Your Quantum Plus, as it comes from the factory,
requires a 230 VAC 50 AMP 4-wire grounded type electri-
cal service and must be in a separate circuit having no
other appliance connected in that circuit. If you do not have
this kind of circuit, a qualified electrician should be called
in to install the necessary wiring. Inadequately sized wiring
or locating the spa too far from the main service panel may
cause a voltage drop which might cause the unit to
malfunction and bring about permanent damage to the
spa’s electrical system. The circuit must also have a ground
wire in order to take advantage of the designed-in safety
features of the spa. Bond according to procedure described
on the next page. Caution: Without proper grounding and
bonding, a system malfunction may cause fatal shock.