Filter
Top Products
www.clearcreekspas.com
www.clearcreekspas.com
TROUBLESHOOTING GUIDE
PROBLEM PROBABLE CAUSE REMEDY
1 .Control Switches do not respond.
A Actuated too rapidly
B. No power to the unit.
A. Wait 60 seconds; system
will be restored
automatically. B. Turn on circuit
breakers.
2 .Heater not functioning. A. Heater mode not selected.
B. No power to heater.
C. Thermostat set lower
than water temperature.
D. High temperature safety
switches tripped.
E. Abnormally low water flow.
F. Heater relay not operating.
G. Heater element failure.
H. Flow switch not operating.
A. Select Heater/Filter mode.
B. Check house circuit
breaker
and ELCB.
C. Turn to desired temperature.
D. Reset buttons on heater after
water has cooled; see *Note if
switches continue to trip.
E. See Remedy 6 below.
F. *
G. *
H. Check Flow switch and plug-in
connection on System Control
Module
3. Heater not functioning but
heater light on.
A. Relay malfunction.
B. Element malfunction.
C. Loose wires
A. *
B. *
C. *
4. Water not clean.
A. Clogged or blocked suction
strainer or skimmer basket.
B. Filter clogged (dirty).
C. Poor water chemistry.
D. Insufficient filtering time.
E. Improper maintenance.
F. High content of solids in water.
G. Filter motor not operating
A. Clean strainer/skimmer basket.
B. Clean or replace.
C. See “Chemistry” section.
D. Run filter.
E. See Maintenance section.
F. Use clarifier or drain and refill
spa.
G. *
5. Abnormal water usage.
A. Leak in suction line, dis-
charge line, or connections. B.
Excessive evaporation and/or
splashing.
A. Repair leak.
B. Use rigid spa cover; lower
thermostat setting.
6. Low water flow from jets. A. Normal operation in FILTER
mode.
B. Normal operation when Water
Rainbow on.
C. Low water level.
A. Select JETS mode for maximum
flow.
B. Turn off Water Rainbow
C. Fill to water levelindicator mark on
skimmer/filter frame.
*Note: The skills and tools necessary for the safe repair of this spa require the services
of qualified service personnel. Contact your Jacuzzi Whirlpool Bath dealer.