Filter
Top Products
www.clearcreekspas.com
www.clearcreekspas.com
OPERATION
Basic Control Set-Up (continued)
• Make sure the circuit breakers are in the ON (1) position.
• Locate the HIGH TEMPERATURE SAFETY
SWITCHES which are raised buttons on the end of the
heater. Push both buttons to be sure it is in the reset
mode. The purpose of both switches is to shut down the
spa if the water becomes excessively hot. If, for some
reason, the switches are tripped, the reset button must
be pushed in for the heater to operate again after the
water has cooled to about 38°C (100°F).
• Set the built-in timer (see below). Use of the timer allows
two modes of operation: timed HEATER/FILTER and
FILTER ONLY. With the SYSTEM switch turned OFF
and the HEATER knob set to the desired tempera-
ture, the timer will activate the heater and filter pump
to operate during the time period set on the timer.
With the SYSTEM switch turned OFF and the
HEATER CONTROL knob turned to its lowest set-
ting, the water will be filtered without heat during the
time period set on the timer.
• Close the redwood skirt door.
CIRCUIT
BREAKER
BUTTONS
HIGH TEMPERATURE
SAFETY RESET
BUTTON
Setting the Timer
The built-in 7-day timer is located in the System Control
Module. The tooth-like tabs that are located on the dial can
be set to activate the filter system for two-hour period on
any day(s) of the week. First turn the program dial gradually
clockwise until the day of the week (7-day timer) and time
of day on the outer dial is aligned with the triangle marker
on the inner dial (two o’clock position). For to-the-minute
setting turn the minute hand clockwise to the exact time of
day. NOTE: Both the correct time and day must be set.
Next slide one of the tabs outward to the time at which you
wish the filter system to operate. Note that the timed
mode can begin at any time of day or night at any
specified day of the week.