Filter
Top Products
27
Program key
Use Program key to display time or enter
Programming menu by pressing and
holding key. In Programming mode, the
following parameters can be set: time, lter
cycle's start time, duration and frequency,
also, Economy mode's start time as well
as its end time and nally the choice of
temperature display unit.
BASIC PROGRAMMING
Setting Filter cycle start time
To program the lter cycle, you must enter
these parameters: start time, duration and
frequency. During a lter cycle, pumps run
for one minute to purge the plumbing,
then CP runs for the programmed number
of hours and the ozonator is activated.
Press Ok key a second time.
The display will show FSxx, with "xx"
representing the starting hour.
Use (+) or (-) key to change setting (01:00-
12:00 AM / PM).
Setting the time
Enter Programming mode by holding Prog.
key pressed down for 3 sec. The display
will show the current time setting.
Setting the hour:
Use (+) or (-) key to change hour setting
(AM/PM).
Setting the minutes:
Press Ok key.
Use (+) or (-) key to change
minutes setting.
Setting Filter cycle duration
Setting of the Filter cycle duration in hours.
If no ltering is required, the duration should
be set to “0”.
Press Ok key a third time.
The display will show Fdxx, with "xx"
representing the duration in hours.
Use (+) or (-) key to change setting (00:00-
23:00 hrs).