Filter
Top Products
TURNING THE POWER ON
Turn the power to the spa on at the main circuit breaker. Verify that your
spa has no error codes. (See page 47) Verify that there is good water
circulation in the spa. The pumps will come on in cycles, for 1 minute
each cycle.
VERIFYING WATER CIRCULATION
1) Open all the jets.
2) Press the Pump 1 key to turn the pumps on or off.
3) Make sure each seat has water ow. Note: On certain spas there is
a diverter valve. Verify where the diverter valve is located.
TESTING THE GFCI BREAKER
NOTE: The electrical service panel for your spa should be equipped
with a GFCI breaker. To avoid the risk of electrical shock, perform the
following safety test before each use of your spa.
1) Make sure the power is turned on at the electrical service panel.
2) Turn on the GFCI breaker. If the breaker stays on, it is functioning
properly.
DANGER: RISK OF ELECTRICAL SHOCK
19
If the GFCI breaker fails to operate as described, there is a possibility
of an electrical shock if the spa is used. Shut off the power at the main
electrical service panel until the source of the problem has been identi-
ed and corrected by a licensed electrician or qualied spa technician.