Filter
Top Products
Electrical wiring 50 Hz
Case 1
The installation of electrical
circuit jumpers is needed
in certain input supply
congurations.
Use uncut jumper as supplied
in the case of an input supply
wiring, single-phase 1 x 230
VAC (32 A max).
Case 2
In the case of an input supply
wiring for a dual phase system
2 x 230 VAC (16 A max), you'll
need to cut off a portion of the
jumper piece.
Proceed as follows:
Use a pair of pliers to rmly
hold the upper half of the metal
jumper, then break off the
other half.
Case 3
Please note that in a 3-phase
system 1 x 230 VAC (3 x 16A)
No jumper installation
is required.
Important!
Safely dispose of the discarded
portion in accordance with the
local waste disposal legislation
in force.
14