Filter
Top Products
12
Groove
SERVICE AND ADJUSTMENTS
REPLACING THE LINE
WARNING: Keep hands and fingers
away from thetrigger switchto avoidacciden-
tal starting during service.
1. Pr ess and hold in the two cap release
latches.
2. Pull cap away from the hub.
Cap
Cap
release
latch
Spool
Hub
Eyelet
3. Remove old spool.
4. Clean entire surface of hub and sp ool.
5. Replace with a pre--wound spool or cut a
lengthof26 feet(8 meters)of 0.065″(1.65
mm) diameter WEED EATER brand line.
Use o f heavier lines could overload and
damage unit.
WARNING: Never use wire, rope,
string,etc., which c anbreak offandbecomea
dangerous missile.
6. Insert end of line about 1/2 inch (1 cm)
into small hole on the inside of the spool.
7. Wind the line evenly and tightly onto the
spool. Wind in the direct ion of the arrow
found on the spool.
8. Push the lineinto the notch, leaving 3to 5
inches (7 -- 12 cm) unwound.
Notches
9. Place spool into hub with cut out area of
spool in line with eyelet (see illustration).
Cut out
area of spool
Eyelet
10. Re m ove line from notch and feed line
through eyelet.
11. Reinstall the spool cap.