Filter
Top Products
4.44 WATLOW Series 988 User’s Manual
Setup Menus, Chapter 4
Setup-Comm
˜
NOTE:
The Communications Menu
appears only on controllers
equipped with communications
hardware (98_ _-_ _ _ _-_R_ _,
98 _ _-_ _ _ _-_U_ _ or 98_ _-_ _
_ _-_S_ _).
See
Data Communications with
the Series 988 Family of
Controllers
for detailed informa-
tion on communications.
MODE
*Address
*Interface Type
Setup Prompt
Baud Rate
Data Bits and Parity
Protocol Type
Enter your settings,
from the controller's
upper display.
MODE
MODE
MODE
MODE
MODE
[COm]
[`Set]
[BaUd]
[Data]
[Prot]
[addr]
[IntF]
❸ Press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > or the
Down-arrow key < to select one of
the prompt values.
Input
Menu
p. 4.2
Output
Menu
p. 4.18
Global
Menu
p. 4.34
Communications
Menu
p. 4.44
[Inpt]
[`Set]
[`Set] [`Set]
[`Set]
[OtPt] [gLbL] [COm]
❶ Begin in the Display Loop, and
press the Up-arrow > and Down-
arrow < keys simultaneously for
three seconds to reach the Setup
Menus.
❷ Press the Up-arrow key > to select
one of the Setup Menus.
…
…
…
[baUD]
[baUD] [baUD]
[baUD]
[9600]
[`300]
[1200] [4800]
[Intf] [Intf]
[`485]
[`422]
Reaching the Communications Menu
Figure 4.44 -
Navigating the
Communications Menu.
*Prompts may not
appear, depending
on controller config-
uration.
C4.wc 5/14/1999 8:49 AM Page 4.44