Filter
Top Products
MODE
*Ramp Rate
*Ramping Function
Auto-tune Set Point
High Power Limit
Low Power Limit
Annunciator
*Event Input 2
Event Input 1
*Crossover Process Value
*PID 2 Crossover Selection
*Algorithm
*Control Type
*Cascade Action
Setup prompt
*Celsius-Fahrenheit
Failure Mode
Error Latching
Enter your settings,
from the controller's
upper display.
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
Event Input (p. 4.40)
PID (p. 4.38)
Ramping (p. 4.43)
*Crossover Set Point Value
[GlbL]
[`Set]
[FaIL]
[`C_F]
[`Err]
[CntL]
[CSAC]
[ALGO]
[Pid2]
[Proc]
[StPt]
[`EiI]
[`Ei2]
[Anun]
[`LoP]
[`HiP]
[AtSp]
[``rP]
[Rate]
4.34 WATLOW Series 988 User’s Manual
Setup Menus, Chapter 4
Setup-Global
❸ Press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > or the
Down-arrow key < to select one of
the prompt values.
Input
Menu
p. 4.2
Output
Menu
p. 4.18
Global
Menu
p. 4.34
Communications
Menu
p. 4.44
[Inpt]
[`Set]
[`Set] [`Set]
[`Set]
[OtPt] [gLbL] [COm]
❶ Begin in the Display Loop, and
press the Up-arrow > and Down-
arrow < keys simultaneously for
three seconds to reach the Setup
Menus.
❷ Press the Up-arrow key > to select
one of the Setup Menus.
[`C_F]
[`C_F]
[``°F]
[``°C]
…
…
…
[```0]
[```1] [```2] [9999]
[rate]
[rate]
[rate]
[rate]
Reaching the Global Menu
Figure 4.34 -
Navigating the
Global Menu.
*Prompts may not appear, depending
on controller configuration.
C4.wc 5/14/1999 8:48 AM Page 4.34