Filter
Top Products
FIG. A FIG. B
5. Three different assemblies can be removed for service.
a. The control system including the control panel. (FIG. A)
b. The pump assembly. ( FIG B )
c. The entire equipment assembly (Control System and Pump Assembly)
6. REMOVAL OF THE CONTROL SYSTEM
a. Lift the topside control pad from the
cowling by prying it up and feed through
the opening under it into the therapy
module.
b. Disconnect the pump power supply cord
from the metal control box.
c. Reach through the access door and
loosen the 2 heater nuts (1 & 2 FIG. A)
7. Reach through the side of the therapy unit and lift
and remove the control system with the control panel
and power cord.
8. Package the equipment so that no damage may be done to the control pad wiring or the
sensors attached to the heater assembly. Leave the GFCI power cord attached to the
equipment and carefully coil it so that no damage may occur during shipping.
9. When the equipment is returned, replace it by reversing the order of removal.
PAGE 27