Filter
Top Products
PAGE 12
E. Filtration Cycles
Your spa digital control has an electronic timer that
has been pre-programmed to automatically run the
filtration low speed pump 3 hours twice a day for a
total of 6 hours, from 8am to 11am, and from 4pm
to 7pm. The heater will come on as needed during
those hours. Note that filtration will also be provided
during the heating cycles, when the spa electronic
thermostat starts the low speed pump and the
heater to maintain the desired temperature.
F. Memory
The temperature setting that is entered into your spa
digital topside control are permanently retained in its
solid state memory. In the event of a power failure,
the temperature setting will be captured and held
until power returns. The temperature setting at the
time of the power failure will be restored when
power returns.
G. Resetting Your Spa
Like your PC at home, your spa electronics could get
corrupted by electrical surges or other interference
resulting in improper operations. To properly reset or
reboot your spa, unplug the GFCI and plug it back
in after 5 full minutes. Then press and hold the
“UP” arrow button for 5 seconds. The topside dis-
play will show 12:00 PM as soon as you release
the “UP” button and the temperature will be reset
to 102ºF, indicating a successful system reset.
AIRCONTROL OPERATION
AIRCONTROL OPERATION -Open to regulate
air to jets. When finished with spa, return pump
to low speed. Close so air induction does not
fight the heater.
JET LAYOUT / USE/ ADJUSTMENT - All jets
have flow control “dial” adjustment. By rotating
the jet face, changing the combination of jets,
and adjusting to what extent they are open or
closed, you have the ability to “customize” each
bank of jets to your individual hydro-massage
needs of flow and pressure.
Remember, as you turn off or reduce the flow of
water out of one jet, you also increase the
pressure and flow through the others. An
important feature of this jet adjustment ability, is
to enhance specific water currents in the Voyager
Spa. For example, if you shut off one entire bank
or jet side of the module and open the other, you
can create a “true” whirlpool effect in the spa
within a few minutes.
Remember that the Voyager has a 2 speed pump.
You can further vary the massage and water
current sensations by changing speeds which
changes the amount of water flow through the
jets.
This is also true of the air control / jet relationship.
IMPORTANT: Always leave at least 2 jets on or
opened so that the pump is not back-pressured.
When finished with the use of the spa, put the
pump into low speed and close the air control.
Directional jet eyes can
be positioned as desired.
Open Closed
Directions for increasing
flow through jets.