Filter
Top Products
VII. LACK OF PRESSURE AT ONE OR
SEVERAL OF THE JETS
Cause:
Jet(s) could be closed.
Solution:
Open jet(s). The flow of the jets is controlled by
the jet finger ring. Adjust the ring to direct the
water to the desired jets. See instructions on
page 12.
Cause:
Obstruction in plumbing.
Solution:
Remove the jet face(s), clean and
re-install. See section on HYDROTHERAPY JETS.
If any of the above does not solve the
problem, (page 12) call Service Center and
mention code "LOW FLOW-1"
IX. THERAPY MODULE LEAKS
Cause:
Loose union(s) at the pump.
Solution:
Unplug the module. Remove door to the unions.
Hand tighten. Do not use pliers. If the leak is
anywhere else, call Service Center for assistance.
X. WATER LEAK THROUGH THE LINER
Cause:
Puncture of the liner.
Solution:
Patch the hole using a vinyl patch kit. A vinyl
patch kit can be obtain at your retailer or by call-
ing the Service Center. In the unlikely event that
the leak is at the seam, call the Service Center to
order your replacement liner.
XI. WATER NOT CLEAR
Cause:
Dirty filter cartridge.
Solution:
Clean or replace the cartridge.
Cause:
Improper water chemistry.
Solution:
See "Balancing your spa water" and "Water
Maintenance" sections on page 13-15.
Cause:
High content of solid in water.
Solution:
Use clarifier or drain and refill the spa.
SERVICE CENTER
Your Voyager Therapy Module has been
designed to minimize service requirements.
There are no user serviceable parts in the
module.
9am - 5pm Mon.-Fri. EST
Toll Free: (877) 240-9457
or (305) 908-8187
Fax: (305) 685-9794
e-mail:
voyager@dmindustries.com
Attn: Voyager Service Center
PAGE 22
Do not try to service the module or the GFCI.
If you have an operation problem, go carefully
through the troubleshooting steps outlined in
the troubleshooting section of this manual. If
you cannot correct the problem, contact DM
Industries Ltd.'s Service Center for assistance
or for the nearest Service Center to you.