Filter
Top Products
3.
rod is positioned under the handle panel. Install hex bolt
previously removed, but do not secure with wing nut at
this time. See Fig. 3-8.
Squeeze the trigger on the joystick and rotate the chute by
hand to face forward. The holes in the chute control input
NOTE: The chute will not rotate without squeezing the
trigger on the joystick.
5.
silver indicator arrow on the pinion gear below the control
NOTE: The joystick will be angled slightly to the right at the
Insert the chute control rod into the pinion gear below the
joystick. Make sure to line up the hole in the rod with the
NOTE: The chute control rod will fit snuggly into the pinion
gear. Support the rear of the dash panel with one hand
while inserting the rod with your other hand to ensure the
rod is inserted all the way into the pinion gear.
NOTE: The hole is a reference for aligning the rod with the
indicator arrow on the pinion gear, and will be visible after
the rod has been inserted.
Top View
9se c t i O n 3 — as s e M b l y & se t-up