Filter
Top Products
Close the flange keepers to secure the chute assembly 2.
to the chute base. The flange keepers will click into place
NOTE: If the flange keepers will not easily click into place,
use the palm of your hand to apply swift, firm pressure to
the back of each.
Chute Directional Control (Model 2410)
Remove the plastic cap (if present), flat washer and hairpin
clip from the end of the chute directional control. See
Fig. 3-5.
Insert the end of the chute directional control into the 2.
lower bracket and secure with the flat washer and hairpin
clip just removed. If necessary, the lower bracket can be
Chute Assembly and Directional Control
(Models 2620, 2840 and 3090XP)
Remove cotter pin, wing nut and hex screw from chute
control head. Remove clevis pin and bow-tie cotter pin
2.
as far into chute control head as possible, keeping the
holes in the rod pointing upward. See Fig. 3-7.
Bracket
se c t i O n 3— as s e M b l y & se t -up