Filter
Top Products
7.
the hole in the rod lines up with the hole in the chute
control input closest to the chute control head and insert
NOTE: The second hole is used to achieve further
engagement of the chute control rod into the pinion
adjustments.
Finish securing chute control head to chute support 8.
bracket with wing nut, clevis pin, and bow-tie cotter pin
Check that the cables are properly routed through the
cable guide on top of the engine. Some models only have
NOTE: For smoothest operation, the cables should all be to
the left of the hex rod.
Set-Up
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins
are included with your snow thrower. Store them in your snow
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
10 se c t i O n 3— as s e M b l y & se t-up