Filter
Top Products
se c t i O n 7 — se r v i c e
Remove the belt from around the auger pulley, and slip the 7.
belt between the support bracket and the auger pulley.
See Fig. 7-5.
Replace the auger belt by following instructions in reverse 8.
order.
NOTE: Do not forget to reinstall the shoulder bolt and
reconnect the spring to the frame after installing a
replacement auger belt.
After replacing the auger belt, perform the Auger Control
Drive Belt
as follows:
To prevent spillage, remove all fuel from tank by running
engine until it stops. Do not attempt to pour fuel from the
engine.
Remove the plastic belt cover on the front of the engine by 2.
3.
Roll the auger belt off the engine pulley.a.
b.
Lift the drive belt off engine pulley.c.
Carefully pivot the snow thrower up and forward so that it
rests on the auger housing.
Remove the frame cover from the underside of the snow 5.
thrower by removing the self-tapping screws which secure
it. Refer to Fig. 7-3.