Troy-Bilt 3090XP Snow Blower User Manual


  Open as PDF
of 56
 
Auger Control

carefully read and follow all instructions below.

is operating safely and properly.
Check the adjustment of the auger control as follows:
When the auger control is released and in the disengaged 


In a well-ventilated area, start the snow thrower engine. 2.

3.
thrower), engage the auger.
Allow the auger to remain engaged for approximately ten 

several times.
With the throttle control in the FAST (rabbit) position and 5.

the front of the machine.
Confirm that the auger has completely stopped rotating 


position and shut off the engine. Wait for ALL moving parts
to stop before re-adjusting the auger control.
To readjust the control cable, loosen the upper hex screw 7.

8.
downward to increase cable tension).
Retighten the upper hex screw.

adjustment has been achieved.

 se c t i O n 3— as s e M b l y & se t-up
 previous next