Filter
Top Products
Maintenance & Adjustments
6
13
Adjusting the Auger Drive Cable
After periods of extended use, and during the break-in period, it
may be necessary to adjust the auger drive cable. Follow these
simple steps to adjust the auger drive cable:
1. Uncouple the power base and the snow thrower
attachment from each other.
WARNING! Always turn off the FLEX™ Power Base
engine and remove the key prior to attempting to
uncouple of the power base from the attachment.
2. Remove the plastic belt cover on the snow thrower
attachment by removing the two self-tapping screws that
secure it. Refer back to Figure 6-1.
3. Looking at the rear mounting plate of the snow thrower
attachment, loosen (but do not remove) the left side hex
screw shown in Figure 6-2.
Note: The other screw (to the right of the hex screw
(previously loosened) is a shoulder bolt that does not need
to be loosened.
Figure 6-2
4. On the front side of the mounting plate, move the cable
tension guide up or down to remove any slack in the auger
drive cable. See the left inset of Figure 6-2.
Note: Be sure that the adjustment does not apply
any pressure on the cable and the actuator arm. This
adjustment is simply to remove the excess slack in the
auger cable as shown in the right handed inset of Figure
6-2.
5. Tighten the left hand side hex screw to complete this
adjustment.
Maintenance
General Recommendations
• Always observe safety rules when performing any type of
maintenance.
• The warranty on this snow thrower does not cover items
that have been subjected to operator abuse or negligence.
To receive full value from the warranty, operator must
maintain the snow thrower as instructed in this manual.
• Periodically check all fasteners and hardware to make sure
these are tight.
WARNING! Before servicing, repairing, lubricating,
or inspecting, disengage all controls and stop
engine. Wait until all moving parts have come to a
complete stop. Disconnect spark plug wire and
ground it against the engine to prevent unintended
starting. Always wear safety glasses during
operation or while performing any adjustments or
repairs.
Engine
IMPORTANT: Refer to the FLEX™ Power Base operator’s manual
for complete engine servicing instructions.
Check V-Belts
Follow instructions below to check condition of drive belts every
50 hours of operation.
1. Remove the plastic belt cover on the snow thrower
attachment by removing the two self-tapping screws that
secure it. See Figure 6-1.
Figure 6-1
2. Visually inspect for frayed, cracked, or excessively worn
out belt. Replace, if necessary, following instructions in the
Service section of this manual.