Filter
Top Products
Engine
Refer to the FLEX™ Base Unit Operator’s Manual for details
regarding all engine-related controls and features.
Drive Control Lever
This lever propels the entire machine forward.
Attachment Control Lever
Squeeze the auger control against the upper handle to engage
the augers; release to disengage the augers.
Auger
When engaged, the auger’s rotation draw snow into the auger
housing and throws it out the discharge chute.
Chute Assembly
Snow drawn into the auger housing is discharged out of the
chute assembly
Chute Handle
The direction of snow throwing corresponds to the direction
of the chute opening. Use the chute handle to turn the chute
assembly in the direction you wish to throw the snow.
Chute Knob
The distance snow is thrown can be adjusted by either raising
or lowering the upper chute. Loosen the chute knob on the side
of the upper chute to adjust. Pivot the upper chute to desired
position, and retighten the chute knob.
Shave Plate
The shave plate maintains contact with pavement as the snow
thrower is propelled, allowing snow close to pavement’s surface
to be discharged.
Skid Shoes
Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces. See the Assembly &
Setup section for details on adjusting the skid shoes.
Chute Clean-Out Tool
The chute clean-out tool is conveniently fastened to the rear of
the auger housing with a mounting clip. It is used to dislodge
and scoop any snow and ice which has formed in and near the
chute assembly.
Chute Handle
Shave Plate
Auger
Upper Chute
Chute Knob
Skid Shoe
Chute Clean-out Tool
Drive Control Lever
Attachment Control Lever
Attachment Control Lever Lock
Chute Assembly
Figura 4-1
Controls and Features
4
10