Filter
Top Products
Starting The Engine
Refer to the FLEX™ Power Base’s operator’s manual for engine
starting and operating instructions.
Couple Snow Thrower Attachment with Power
Base
1. With the kickstand UP on the FLEX™ Power Base, as shown
in Figure 5-1, roll it over to the snow thrower attachment.
Figure 5-1
2. Tip the FLEX™ Power Base forward, engaging the top
mounting tab with the mounting handle on the snow
thrower attachment, see Figure 5-2.
Figure 5-2
3. Once the top mount is engaged (1), and with both hands
on the handle grips, tip the unit backwards somewhat
swiftly to engage the bottom mounts (2). See Figure 5-3.
1
2
Figure 5-3
Note: The operator will be able to hear the lower mounts
engage and lock when coupled properly.
To Uncouple the Snow Thrower Attachment from Power Base:
Fully stop the power unit engine before attempting to perform
any maintenance steps or uncoupling of the attachment. Never
attempt to uncouple the power base from the snow thrower
attachment WITH the engine running.
WARNING! Always turn off the FLEX™ Power Base
engine and remove the key prior to attempting to
replace the shear pins or uncoupling of the power
base from the attachment.
1. Put the kickstand down.
2. Tip the FLEX™ Power Base forward to disengage the
bottom mounts, then the top mount.
3. Move the FLEX™ Power Base away from the snow thrower
attachment.
Note: With the kickstand deployed in the downward
(unlocking) position, the FLEX™ Power Base will rest
comfortably in a parked position.
Operation
5
11