Filter
Top Products
Assembly
ASSEMBLY
Your generator requires some assembly and is ready for
use after
it
has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-888-6
1
1-6708.
Remove Generator From Carton
I.
Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3.
Open carton completely by cutting each corner from
top to bottom.
4.
Leave generator on carton to install wheel
kit.
Install Wheel Kit
NOTE:
Wheel kit is.not intended for over-the-road use.
You will need the following tools to install these
components:
112" or 13mm wrench
Socket wrench with a
112"
or 13mm socket
Pliers
Refer to Figure
I
and install the wheel kit as follows:
I.
Tip generator so that engine end is up.
2.
Slide axle through both mounting brackets.
3. Place a wheel on each side with air valve facing out.
4.
Place a washer on axle and then place an e-ring in axle
groove.
5.
Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
.
6.
Repeat step 3 through
5
to secure second wheel.
Hex Nut
-