Filter
Top Products
13
Trouble-Shooting
Disconnected Signals
• If the receiver unit does not receive a transmission from a remote
channel for 1 hour, the display will show dashes. To correct this problem:
1. Go to the remote location of that channel to check that the unit is
properly positioned, within the appropriate transmission range.
2. If new batteries are faulty on the initial installation, install fresh
batteries. If you did not notice the Low Battery icon warning and
the product performed correctly after initial set up, the batteries
have lost their charge. Replace batteries (see the Power Sources
section of this manual.)
3. Check to make sure the transmission path is clear of obstacles
and interference.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
Modifications not authorized by the manufacturer may void users
authority to operate this device.
Note: FCC ID: L5CW044TX-F (transmitter)
unit
NOAA Weather Radio (continued)
NOAA Standby mode:
Stand by mode will mute the weather radio until an alert broadcast is
received. While the radio is on, press “NOAA ON/OFF” once to enter
NOAA standby mode. The “STANDBY” icon appears and the sound will
mute. When an NWS (NOAA) alert broadcast is received, the unit will
automatically switch to “NOAA On mode” and broadcast for 5 minutes.
NOAA Off mode:
While the radio is in Standby mode, press “NOAA ON/OFF” once to
switch off weather radio completely.
NOTE: To conserve battery power, it is recommended to always use the
adapter to power the unit while the weather radio is on. The radio can
still operate with backup batteries alone during power outages.