Filter
Top Products
SERVICE / ADJUSTMENTS
REMOVING THE MOWER DECK
1. Turn off engine and engage parking brake.
2. Rotate cutting height lever
counterclockwise to lowest cutting position.
3. Remove bolt from pickup point located at
the front of the deck.
4. Remove cotter pins on rear hanger points
and slide out stabilizer bars.Disconnect
tension spring bolt from tension bracket.
5. Remove belt from mower pulley and
electric clutch.
6. Slide mower deck from under unit.
INSTALLING THE MOWER DECK
1. Be sure the cutting height lever is in the
lowest position.
2. Position mower deck under unit.
3. Install belt around mower pulley and
electric clutch.
4. Install stabilizer bars into rear hanger
brackets through lift points and install
cotter pins. Be sure eye bolt is between
bracket sides.
5. Install bolt in front hanger bracket
passing through eyebolt in the same
manner as rear and tighten snug.
6. Reattach tension spring bolt and tighten.
13
Remove belt
Remove eye-bolts (2 rear & 1 front)
It is recommended to remove the
deck to sharpen the blades.