Filter
Top Products
CAUTION: Use Only Sundance SunScents
TM
Fragrances in your new hot
tub. Never remove the SunScents
TM
beads from their webbed bag for any
reason. Install webbed bead bag directly into SunScents
TM
dispensor.
Never use this dispenser for any other type of fragrance. Always make
certain that the dispenser cap is securely in place before operating the
hot tub’s air blower.
Automatic Filtration Cycles
FILTRATION CYCLES
Your hot tub’s control system activates automatic filter cycles, during which
pump 1 turns on in low speed to move water through the filter. This water
movement also provides important skimming action to remove debris and
suspensions from the water’s surface, minimizing the “bathtub ring” effect.
These filter cycles are only active when the hot tub is in the ‘Standard Mode’.
When an automatic filter cycle activates, the LCD screen displays the follow-
ing message:
FILTER
CYCLE ON
NOTE: After a long filter cycle, you may notice that the water temperature
is greater than the temperature setting. This can happen in such a well
insulated hot tub because, even though the heater turns off as intended,
the transference of heat from the pump continues to add warmth to the
water. If the water temperature is above 95°F (35°C) and two degrees
above your set temperature, the circulation pump (and ozone generator, if
equipped) will shut off until the water temperature cools to the set tem-
perature. In warm weather, it may be necessary to reduce filter cycle run
time to prevent this type of heat overrange from occuring.
Preset Filter Cycles
Your hot tub comes with four 30-minute filter cycles already pro-
grammed in, beginning at 6:00 a.m., noon, 6:00 p.m. and mid-
night. You can easily change the start time, or the cycle length for
any of these cycles to suit your individual needs by following the
steps in the next section.
Clean Up Cycle:
Clean up cycle is once per day in both Standard and Economy mode at 12:00
PM for two minutes. This is not user programmable. Pump 2 and Blower activate
for one minute to circulate any water in the plumbing. After 1 minute they both
go off and Pump 1 runs for 1 minute. If the filter cycle is also set at 12:00 PM
pump 1 will continue to run for the duration of the filter cycle.
Page 19