Filter
Top Products
Operating Instructions
Your Sundance hot tub has a touch-sensitive control panel, Massage Selector
valves and air control knobs located on the top rim of the hot tub (See Ill. 3,
items 1, 2, 4, 7). These controls let you operate many of the special functions
of your Sundance hot tub. By familiarizing yourself with the following infor-
mation, you will be able to gain the full benefit afforded by the various func-
tions of your hot tub.
VIEW
Pressing the sensor pad labeled VIEW inverts the main four-digit display on
the Command Center’s LCD screen to allow easy reading from either inside
or outside the hot tub.
LIGHT
The LIGHT sensor pad activates both the underwater light and the light sym-
bol on the LCD screen when touched. To reduce the brightness of the light,
touch the sensor pad again. A third touch will result in an even lower level of
illumination. A fourth touch turns the light off. If left on, the light will auto-
matically turn off after one hour.
There are two colored lenses included with your hot tub which may be placed
over the light lens inside the hot tub. To remove a lens, pull straight out. To
install a lens, align tabs and push straight in. Your hot tub comes with clear
lens installed.
AIR INJECTION
When the AIR sensor pad is pressed, the air blower forces air through the
injectors located in the seats and footwell. The bubbles symbol above the sen-
sor pad appears whenever the air blower is on. An electronic timer automat-
ically turns the air blower off 20 minutes after it was turned on.
The air blower automatically activates for 1 minute at the start of Clean Up
cycle. This clears the lines of the air injector system to help ensure that all
water is exposed to sanitizer.
Page 15