Filter
Top Products
Page 26
for a change when you cannot control sudsing and/or you can no longer
get the normal feel or sparkle to the water even though the key water
balance measurements are all within the proper parameters.
WARNING! READ THIS BEFORE DRAINING: To prevent
damage to the spa’s components, turn off power to the spa
at the circuit breaker before draining it. Do not turn the
power back on until your spa has been refilled.
CAUTION: There are certain precautions to keep in mind
when draining your spa. If it is extremely cold, and the spa is
outdoors, freezing could occur in the lines or the equipment
(see “WINTERIZING”, page 28. On the other hand, if it is hot
outdoors, do not leave the spa’s surface exposed to direct
sunlight.
To drain your spa, perform the following steps:
1. Turn off power to spa at breaker.
2. Locate and remove the synthetic cabinet door screws and door.
The door is located directly below the control panel and is easily
identified by it’s vertical cooling slots.
3. Pull drain hose from equipment area
(Figure-A)
4. Hold drain hose above water line, then
unthread drain cap from hose using a
counterclockwise rotation. Place drain
hose on ground to start drain making
sure to direct water away from spa
(Figure-B).
5. After spa has completely drained,
reinstall drain cap on drain hose fitting
by turning it clockwise until finger
tight! DO NOT OVERTIGHTEN!
6. Coil drain hose up and place back inside
the spa equipment bay (Figure-A).
7. Reinstall synthetic cabinet door and
screws.
8. After refilling spa, turn on power and
follow the “Spa Fill Up Procedure” listed on page 14.